I finally got around to thinking about what I was going to present at next month's meeting yesterday. I have plenty of time if I get started now..but in my heart I know I'll be putting the finishing touches on it at the last minute. I've always been a procrastinator by nature.
I wrote down a few things that I think would be of interest to the users in our group:
1. Types of creation
a. Start with a base
i. Gage tables
b. Start with edge profile
c. Lofted sheet metal
d. Convert to sheet metal tool
e. Imported solids/surfaces
2. Adding bends
3. Closing corners
4. Good/bad practices
5. Flat pattern options
I wrote down a few things that I think would be of interest to the users in our group:
1. Types of creation
a. Start with a base
i. Gage tables
b. Start with edge profile
c. Lofted sheet metal
d. Convert to sheet metal tool
e. Imported solids/surfaces
2. Adding bends
3. Closing corners
4. Good/bad practices
5. Flat pattern options
6. Making the drawing
As I look over the list I thought that maybe I should try to get some input from the members of the group on what they would like to see. So here's your chance, tell me what you would like presented and I'll try to oblige as best as I can.
Add a comment with you suggestion.